Günümüzde, hayat kalitesinin artması ve birçok ülkede sanayinin gelişmesi dünyadaki enerji talebinin artmasınasebep olmuştur. Ayrıca, geleneksel enerji kaynakları azalmaya başlamıştır. Bu sebeplerden dolayı yenilenebilirenerji kaynaklarına özellikle de güneş enerjisine olan ilgi her geçen gün artmaktadır. Güneş enerjisi, şebekedenbağımsız sistemleri enerjilendirmek için kullanılan çekici bir enerji kaynağıdır. Gelişmekte olan ülkelerdeşebekeye erişimin olmadığı yerlerde özellikle kırsal alanlarda su pompalanması gibi pek çok uygulamalardakullanılmaktadır. Fotovoltaik (photovoltaic, PV) sistemlerden elde edilen enerji değişen çevre koşulları altındaazalmaktadır. Bu nedenle, PV sistemlerden maksimum enerjiyi elde etmek için maksimum güç noktası takibiyapılmaktadır.Yapılan çalışmada, fotovoltaik enerji ile çalışan su pompalama sistemi uygulaması gerçekleştirilmiştir.Sistemden elde edilen verimi arttırmak için maksimum güç noktası izleyici(MGNI)kullanılmıştır. MGNI olarakDeğiştir&Gözlemle (Perturb&Observe, P&O) algoritması kullanılmıştır. MGNI algoritmasının sistemdeuygulanması TMS320F2812 DSP işlemcisi ile sağlanmıştır. Sistemden elde edilen enerji doğru akım (DA)olduğu için ve su pompa motoru da PV sisteme doğrudan bağlandığı için DA su pompası motoru kullanılmıştır.Uygulama, sistemde maksimum güç noktası izleme algoritması kullanılarak ve kullanılmadan gerçekleştirilmişolup her iki durumdan elde edilen güç değerleri karşılaştırılmıştır. MGNI kullanılarak elde edilen verimin,MGNI kullanılmadan elde edilen verimden daha iyi olduğu gözlenmiştir.
Nowadays, the increase in quality of life and the development of industry in many countries have led to anincrease in energy demand in the world. Due to these reasons, interest in renewable energy sources, especiallysolar energy, is increasing day by day. Solar energy is an attractive source of energy used to energize off-gridsystems. In developing countries, it is used in many applications such as water pumping especially in rural areaswhere there is no access to the grid. The energy obtained from photovoltaic (PV) systems is decreasing underchanging environmental conditions. Therefore, maximum power point tracking (MPPT) to obtain maximumenergy from the PV system is carried out.In this study, implementation of PV based water pumping system was carried out. MPPT was used to increasethe efficiency obtained from the system. Perturb&Observe (P&O) algorithm was used to track maximum powerpoint. Implementation of the MPPT algorithm in the system was provided by the TMS320F2812 DSP processor.Direct current (DA) water pumping motor was used because the energy obtained from the PV system is DA andthe water pump motor is directly connected to the PV system. The applications were performed with and without using the MPPT algorithm in the system and the power values obtained from both cases were compared. It hasbeen observed that the efficiency of PV system with MPPT algorithm is better than without MPPT.